HPI Racing Servo Sparepart #110650
This waterproof, digital, metal gear servo is ideal for bashers and racers looking for a tough and durable servo for absolutely any kind of condition.
Use this in your truck, buggy, touring car, monster truck - any kit that requires a standard-size servo to handle whatever you can drive through!
Operating Voltage: 4.8-6V
4.8V: Speed: 0.13 sec/60 degrees, Torque: 7kg-cm
6V: Speed: 0.11 sec/60 degrees, Torque: 10kg-cm
Servo Spline: 25T
Main case: 38x41.8x20.2mm (excluding mounting tabs, servo spline, & cable outlet)
Mounting tab hole centres: 51.1x9.8mm
Weight: 60g (excluding servo horn)
- HPI Savage XL Flux
- HPI Trophy Buggy Flux
- HPI Trophy Truggy Flux
- HPI Vorza Flux
- HPI Trophy Buggy 3.5
- HPI Trophy Truggy 4.6
- HPI Venture FJ Cruiser
- HPI Savage XS Flux
- HPI WR8 Ken Block Flux
- HPI WR8 Ken Block 3.0
- HPI RS4 Sport 3 Falken Porsche
Please note: Waterproof guarantee is voided if servo case has been opened.
NOTE: Before driving in wet conditions, make sure that all electronics fitted to the vehicle are safe to use (marked as water-resistant or waterproof), or that they are fully enclosed and protected from water and moisture (such as in a sealed receiver/battery case). Fans mounted on speed controllers are not water resistant - we recommend to disconnect the fan from the ESC before driving in wet conditions and allow it to dry fully before reconnecting the fan power. Lubricate exposed metal drivetrain parts such as bearings, outdrives and diff shafts before driving in wet conditions. Motors are not intended for submerged use and may be damaged if used when under water. After driving in wet conditions, make sure to rinse off dirt and any corrosive liquids like saltwater with plain water and re-lubricate metal drivetrain parts.